User Manual

Visit our Page LaisDcc
TM
Decoders Manual [e-mail]
www.laisdcc.com 2002-2018 ©LaisDcc
TM
14 / 17
e.g. CV10 = 15 will make Back-EMF turn off at speed step 15.
m) CV59, Passenger/Coaches Light F0 Control
Attention: When you want to use this function, please make sure the F1, F2 is turned
off before setting. Or else the F1 and F2 will not control by F0.
CV59=0,
Function turned off
CV59=1,
Function 1/Green Wire, Function 2/Purple Wire
will be flicker when you use F0 to
power it on. Later it will stay on. Both F1 and F2 control by F0.
CV59=2,
Forward Headlight FL(F0F)/White Wire, Reverse Headlight FL(F0R)/Yellow Wire,
Function 1/Green Wire, Function 2/Purple Wire will flicker when use F0 to power
it on, then it will stay on. All lights control by F0.
n) Troubleshooting:
Every decoder was tested before it was packed, so we are sure that they are OK
and ready to use when you buy them. Nothing can go too badly wrong if the loco
ran well before you added the decoder, the decoder is installed correctly and you
pre-checked your installation on the program track as we advised, before putting it
on the main line!
Nothing happens:
* Have you selected the address? If it’s a new decoder it will be 3. If you did it
a while ago & you can’t recall
its number then reset the decoder. it will now be 3 again.
* If it is not reading or running and you KNOW the address, be sure that it is
not suffering from loco failure or a short circuit in the wiring or it will be damaged.
And please make sure you are not lock your decoders.
Loco runs reverse when the controller says forward.
* Please remove and reverse the 8 pin plug (or if you hard-wired the loco,
change over the orange and gray wires at the motor) Alternately you can add 1 to
the value already in CV29.
Light / functions will not work!
* Have you turned the lights ON with Function 0 (zero) and also tried the
direction switch – remember white and yellow functions are both always directional