User manual

Bachmann Europe Plc
6 H0 1:87
The railcar also need not be opened to lubricate the gear parts. It is perfectly suffi cient to
swivel the motor bogie to one side as shown in Fig. 6. Then you can look between bogie
and running gear and see the worm and worm wheel (O) and use a pipette to oil all the gear
parts (Z). Then run the railcar up and down a little. This ensures that the oil is distributed
evenly. Use commercially available oils and use a fi ne cannula or a needle.
Caution: Do not use cooking oil or hand cream!
Fig. 6
Z
O
Z
Z
If you have decided on running your
LILIPUT model using a three rail AC
system, please observe the following:
This model has a digital decoder installed
(ESU Lokpilot) located in unit 100, which
can be used to power your vehicle either
on an analogue basis (16 volt AC) or digi-
tally. Please consult the operating manual
supplied by ESU for details on how the
decoder works.
A slider is installed on the turning bogie
of the end carriages 100 and 600 (Fig. 7)
for power pick up from the centre rail.
This picture shows the installed slider.
Your Model as an AC Variant
Fig. 7
R