User manual

Bachmann Europe Plc

H0 1:87 5

Installing a Loudspeaker

The railcar already comes completely

prepared for locomotive sound operation.

The 21-pin sound decoder (SD) can be

plugged in vertically on the interface.

The holder of the loudspeaker (M) and

the two solder pins (SPK) for the wires

are located in unit 100 near the gang-

way (Fig. 5).

To install, please remove the body. To

do this ﬁ rst remove the two screws (S)

on the underside, then pull the front

part forwards (Fig. 5a). By splaying (A)

the two outer walls of the body you can

then loosen the body from the bogies.

Reﬁ tting is effected by following the

sequence in reverse.

Fig. 5

SPK

Looking after your Model

In order to ensure that your model has a long service life, the railcar should undergo mainte-

nance at regular intervals. The model need not be opened to do this. It is perfectly sufﬁ cient

to turn the model over on a soft base as shown in Fig. 5a, but please be careful not to

damage the roof parts or the pantograph in the process. Clean the wheel contacts using

cotton wool buds soaked in spirits and then clean the wheels. However, please do not turn

the drive wheels by hand in any circumstances.

After cleaning please use a drop of machine oil to lubricate

the bearing points (L) shown. It is advisable to carry

out maintenance work after approximately

30-40 hours of operation.

the bearing points (

) shown. It is advisable to carry

out maintenance work after approximately

30-40 hours of operation.

Fig. 5a