User manual

Bachmann Europe Plc

H0 1:87 3

Unit 600 Unit 500 Unit 400 Unit 300 Unit 200 Unit 100

To uncouple (Fig. 2b)

insert a screwdriver

from the side and

press the coupling

collar (H) down-

wards. You can then

separate the units.

Uncoupling the Units

Fig. 2b

Putting your DC Model into Operation

Altering the default settings and opening unit 100

The DC model in its default setting has been connected so that the power pick-up is effected

via the wheels of the two end cars. If you would like to alter the default setting a little, please

open the separate roof section near the gangway area of unit 100 as shown in Fig. 3.

To do this ﬁ rst remove the gangway

bellows with the moulded retaining

pins (Z). You can then unclip and

remove the roof section (D) by lifting

it upwards.

Apart from the digital interface you

can see three switches S1, S2 and

S3 (Fig. 3a).

Fig. 3