User manual

Bachmann Europe Plc

2 H0 1:87

Unit 600 Unit 500 Unit 400 Unit 300 Unit 200 Unit 100

Preparing the Model

Please carefully remove the individual units from the blister packaging. Units 100 and 600

each come with a motor. However, only unit 100 (Fig. 1) with a coupler retaining collar (H)

can be used on its own for test purposes.

Unit 600 only runs when connected with the other units.

Fig. 1

Coupling the Units

The models are ﬁ tted with special electrically conducting couplings. Place the railcar unit 100

and the middle carriage 200 slightly apart on the rails. Always make sure when coupling up

that two non-matching coupling parts (with and without retaining collar H) are facing opposite

each other Fig 2.

Now carefully push the units towards each other until the couplings touch.

We recommend slightly

lifting the two ends of the

carriages by about 2 cm and

to place the retaining collar

(H) on one of your ﬁ ngers

for support as shown in

Fig. 2a. This allows the two

couplings to be gently inter-

connected until the coupling

collar engages without one

part being pressed down-

wards.

Repeat this process to

couple up the other units.

Please pay attention to the

correct sequence of units.

Fig. 2

Fig. 2a

Once the units have been coupled, the railcar train is ready to run. The four-part basic model

consists of the units 100, 200, 400 and 600. The SBB and WESTbahn also run six-part

railcar trains. To cater for this LILIPUT offers for each an add-on set; which consists of units

300 and 500.

Please consult the overview in Fig. 1 for the correct sequencing of units.