Installation Guide
STEP 3 - CUTOUT COUNTERTOP & DRY FIT
Drill a starter hole near the cutout line. e drill •
hole must be large enough to allow the jigsaw
blade to t through. (Figure 3.1)
Use a jigsaw with appropriate saw blade to •
cut the countertop opening along the cutout
line. Dierent countertop materials may
require dierent cutting method. Professional
consultation is recommended. (Figure 3.2)
Dry t the sink by dropping it through the •
opening and make any adjustment if necessary.
e sink should sit ush with the countertop.•
STEP 4 INSERT MOUNTING BRACKETS
AND FASTENERS TO SINK
Exclusive Heritage top mount sink has built-in “U”
channels on the underside of the sink for mounting
brackets or clips. e mounting brackets and
fasteners are designed to clamp the sink edge to the
countertop for a stronger support.
Insert the brackets and fasteners into the •
U-channels around the underside of the sink
rim. e brackets should be placed near the four
corner as well as the center.
(Figure 4.1, Figure 4.2)
Do not tighten the screws at this point.•
Apply a bead of silicone adhesive along the edge •
of the hole in the countertop.
Figure 3.1
Figure 3.2
Figure 4.1
Figure 4.2
TOP MOUNT SINK APPLICATION