Instructions / Assembly

68
DETAILED MAINTENANCE
TWIST SHIFTERS
Twist Shift – Installation
1. Slide front twist shift assembly over left side of handlebar leaving proper clearance for handlebar grip. If necessary, move the brake
lever to accommodate twist shift and handlebar grip.
2. Rotate assembly until cable exits beneath brake lever with adequate clearance for brake lever movement.
3. Firmly tighten recessed clamp screw. Installation torque should be 20 in.-lbs.
4. Slide the two 7/8” plastic washers over handlebar. The washers prevent the grip from interfering with twist shift rotation.
5. Slide handlebar grip over handlebar. Thread the cable inner wire through cable housings and frame, and attach to derailleur. Make
sure that the cable is in the V groove at the derailleur attachment bolt. If trimming the cable housing is necessary, be sure to replace
the housing end cap.
6. Adjust indexing.
7. Slide rear twist shift over right side of handlebar and repeat steps 2 – 6.
8. Actuate front and rear brake levers to be certain of proper operation. If twist shift interferes with brake lever movement, rotate brake
lever or twist shift. Check for proper lever operation again.
Grip 7/8 Plastic Washer
Barrel Adjuster Cable