Product Manual

Page 7 of 13
(2) Remove the bolts that attach the guide roller bracket to the support post.
(3) Rotate the guide roller bracket to the correct position, replace bolts, and tighten.
3. Using the four holes in the base, mount the reel in the desired location. Be sure to use
appropriate hardware and tighten securely.
4. Apply Teflon tape or pipe sealant to supply line threads, attach to the reel inlet, and tighten. The
other end of the incoming line can now be connected to desired supply source.
5. If the hose has been supplied with the reel, apply Teflon tape or pipe sealant to the outlet fitting on
the reel hose, then attach it to the desired tool or nozzle. Check the connection for leakage; also
check the hose reel for correct operation.
6. If the hose stopper adjustment is required, pull the hose from reel and allow it to latch at the
desired length. Loosen the stopper bolts, and slide the stopper to a position close to the hose
guide. Tighten the stopper bolts and unlatch the reel.
Installation of Hose
1. Securely stabilize the reel.
2. Facing the swivel fitting side of reel, turn the drum clockwise by hand, until the rewind spring is
tight, and drum has latched. As an extra precaution while installing the new hose, secure the drum
in the latched position.
3. Insert end of the hose through guide roller bracket, and feed through the opening in the center of
the drum hub.
4. Screw the fitting into the swivel and tighten. Note: To avoid damage to the swivel, use a wrench to
support the swivel fitting while tightening the hose.
5. Attach the hose stopper on the other end of hose, near the outlet fitting.
6. Carefully release the drum latch, and slowly allow the hose to wind onto the reel.
Wall