Product Manual

Page 10 of 13

If the spring

does not

work well…

The spring tension

needs to be

adjusted.

Adjust the spring tension.

1. Pull out approximately 6 feet of hose and allow the drum to

latch.

2. Remove hose stopper from hose, and feed hose back through

guide.

3. Wrap the pulled hose one time around the drum to increase

tension or un-wrap hose one time from drum to decrease tension.

4. Re-insert hose through guide, and install stopper onto hose

end.

5. Unlatch the drum and check tension. Pull hose from reel, and

adjust stopper position if necessary.

If air leaks

out…

The hose is

broken.

Replace the hose.

1. Disconnect air source.

2. Pull out all of the old hose and latch the reel in this position.

For added safety, secure drum in the latched position.

3. Carefully disconnect hose from male fitting in axle center, and

remove old hose.

4. Insert new hose through guide roller bracket, and feed through

the opening in the center of the drum hub.

5. Apply thread tape to fitting in axle center, then screw hose onto

fitting and tighten.

6. Install hose stopper on the other end of hose.

7. Carefully release drum latch, and slowly allow hose to wind

onto the reel.

Parts Diagram

Parts List

Reference

Part Number

Part Description

Quantity

Support Bracket Arm

Support Bracket

Assembly Hub Bearing