Installation Guide

ManualsBrandsUnbranded ManualsLawn & GardenHolland Paver Gray/Charcoal Concrete Interlocking Patio Stone (Common: 4-in x 8-in; Actual: 3.88-in x 7.75-in)

4x8 HOLLAND PAVER

A timeless classic, the Holland Paver is a versatile product ideal for

walkways, paos and garden paths. The ttraditional brick shape gives a

classic look that can be used in a variety of patterns, including

herringbone, basketweave and running bond.

INSTALLATION INSTRUCTIONS

Refer to www.call811.com before digging or excavation

begins. Dig entire area where pavers are planned ap-

proximately 6” deep and 6” longer and wider than

desired ﬁnal dimensions. Remove any grass, sod, roots,

large rocks and/or organic material.

Use a vibratory plate compactor or hand tamper

to compact the new excavated area. Add ap-

proximately 2”of paver base material, spraying

with water to keep moist while compacting.

Repeat this process until desired thickness of

base is reached. (typically approx. 6”) Keep in

mind that any elevaon inconsistencies on the

compacted base will be evident on ﬁnished

paver surface.

Place two pieces of 1” outside diameter pvc or steel

pipe on compacted aggregate base with a comforta-

ble workable space between the two pipes.

(approx. 3’). Place paver sand between pipes and

use a wood 2x4 or aluminum screed to evenly

screed ﬁne paver sand on top of compacted base

material. Keep repeating this process for entire

base area being careful not to disturb screeded

sand. Once pipes are removed, ﬁll in area with

loose paver sand and smooth over with straight

edge.

Install PVC edge restraint (recommended) per the man-

ufacturer’s instructions. Lay pavers in loose, un-

compacted paver sand, using a rubber mallet to make

minor adjust pavers if necessary. Do not pound pavers

into place with mallet. Vibratory plate in next step will

compress pavers into sand. Keep paver joints tight to

each other laying in the pattern of your choice. Use of

string lines is suggested to ensure that vertical and

horizontal joints maintain alignment during installation

for the most even appearance.

Run vibratory plate or use hand tamper to com-

press pavers into loose sand setting bed. Care

should be taken in this step not to scuﬀ or exces-

sively scratch paver surface. Use of cardboard

sheets or rubber mats under tamper plate are sug-

gested.

Sweep dry polymeric sand into joints between

pavers after initial compaction, being sure to follow

manufacturer’s recommended installation instruc-

tions. You are now ready to enjoy your 4x8 Holland

Paver project