Full Product Manual

B-1
OPERATION
OPERATION
Safety Precautions
The manufacturer does not accept any liability for
damage to the product caused by a failure to follow the
cations made to equipment or by negligence during
installation, use, maintenance and repair of the product
mentioned in the safety pages of this document and any
corresponding accessories.
require additional safety instructions. Immediately
contact your supplier if you detect a potential hazard
when using the product.
The operation of portable welding table
equipment is affected by various factors
including proper use and positioning of the
equipment, maintenance of the equipment
involved. Worker exposure level should be checked upon
installation and periodically thereafter to be certain it is
within applicable federal, state and/or local regulations
and guidelines (i.e. OSHA PEL and ACGIH TLV limits in
the U.S.).
If the product is used in combination with products or machines
mentioned in the safety section of this manual, the safety
instructions in the documentation of these products also apply.
• Routinely inspect the product and check it for damage.
• Use common sense. Stay alert and keep your attention to your
work. Do not use the product when you are under the
•
• Never install the product in front of entrances and exits which
must be used by emergency services.
• Make sure that the facility where the equipment is installed
•
accordance with applicable local, state and federal
regulations and guidelines, such as OSHA PEL.
FUMES and GASES can
be dangerous.
Welding may produce fumes and gases
hazardous to health. Avoid breathing these
fumes and gases.
When welding, keep your head out of the fume. Use
enough ventilation and/or exhaust at the arc to keep
fumes and gases away from the breathing zone. When
welding with electrodes which require special ventilation
such as stainless or hard facing (see instructions on
container or MSDS) or on lead or cadmium plated steel
and other metals or coatings which produce highly toxic
fumes, keep exposure as low as possible and within
applicable OSHA PEL and ACgIH TLv limits using local
in some circumstances, outdoors, a respirator may be
required. Additional precautions are also required when
welding on galvanized steel.
Fire hazard!
solids or liquids. Never use the product for
hydrochloric acid) or sharp particles.
WARNING
WARNING
WARNING
PORTABLE WELDING TABLE
hazardous chemicals, if recirculated, should be tested in