Manual of dehumidifier Model No.
Attention: To prevent any internal damage, it is very important to keep refrigeration units (like this one) upright throughout their journey. Please leave it standing upright and outside the box for 24 HOURS before plugging it in. Your dehumidifier comes with two types of water pipes. 1.one is a thin pipe with an inner diameter of 5 mm and a length of 2 meters. (This pipe is suitable for the drainage function of the pump) 2.One is a thick tube with an inner diameter of 9mm and a length of 1 meter.
Content Important Notice...............................................02 Important Safety Instructions..........................03 Location & How it works ..................................05 Product Overview..............................................06 Operation Instruction........................................07 Removing Collected Water................................09 Care and Cleaning & Storage.............................11 Troubleshooting................................................
IMPORTANT NOTICE Thank you a lot for choosing Shinco's dehumidifier, let it be a member of your family to protect the health of the whole family. Please read the manual carefully before you use the dehumidifier, it will help you operate the machine better, so as to achieve the best effect and extend the life of the machine. IMPORTANT NOTICE BEFORE FIRST USE: • To prevent any internal damage, it is very important to keep refrigeration units (like this one) upright throughout their journey.
Important Safety Instructions Warning • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating the unit. This appliance is for indoor use only and intended for use in a domestic environment only. Any other use is not recommended by the manufacturer and may cause fire, electrical shocks or other injury to user or property. If you are in any doubt about the suitability of your electrical supply, have it checked and if necessary, modified by a qualified electrician.
• • • • • • • • • • • • Before moving the appliance,the water tank should be emptied. The handle on the appliance is designed to aid in its movement and should not be used to support the full weight of the dehumidifier. When carrying the unit, it should be kept upright and sufficiently supported from its base. The appliance must be placed in a room without sources of ignition (for example: open flames, an operating gas appliance or an operating electric heater).
Location & How it works Location • TO REDUCE NOISE LEVELS: Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the unit is running. Our dehumidifier uses compressor technology to extract water from the environment. • A badly positioned dehumidifier will have little effect. In positioning the dehumidifier,please ensure circulation of air is not restricted around the unit. Maintain a minimum clearance of 20 cm (8 in) on the sides and back of the dehumidifier and 50cm (19.
Product Overview 6
Operation Instruction 1. Plug the power cord into a properly grounded 115 volt AC outlet. 2. To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of AUTO mode and low fan speed. And the default dehumidification is 50%.And the unit will display the RH,if the room humidity drops to 50%, the machine will automatically shut down. to switch between automatic mode(when it reaches the humidity 3.
5.You can also press to change the fan speed to HIGH or LOW. The indicator light will show the setting you have selected. A higher fan speed will result in quicker moisture removal. 6.Then to run the dehumidifier for a preset amount of hours, press ."0" blinks on the display. Set the time you wish the appliance to operate between 1 and 24 hours. And you can set time to turn on this machine by pressing this button in standby. 7.
Removing Collected Water There are three ways to remove collected water: 1. Use the bucket When the bucket is full, remove the bucket and empty it. Do not move the unit at this time otherwise water may spill on the floor. Press sides of bucket gently to unclip the bucket from the unit. Remove the bucket as shown in the photographs below and empty the bucket. Discard water from bucket. Water is not potable and cannot be used for drinking 2.Pump drainage.
3.Continuous Drainage: Water can be automatically be emptied into a floor drain by attaching the dehumidifier to a water hose. • Cut off the power; • Unscrew the water cap counterclockwise and pull out the rubber water plug； • Connect the water pipe (Inner diameter * wall thickness * length= 9mm * 2mm * 60cm) to the drainage outlet. Note: Make sure the connection is tight and there is no leaking.
Care and Cleaning & Storage Warning: Turn the dehumidifier off and remove the plug from the wall outlet before cleaning. 1. Clean the bucket Clean the bucket with water every two weeks. 2. Clean the air filter Clean the filter with potable water at least once every 30 days. (Notes: It must be air-dried naturally after cleaning. Never use any type of dryer.) 3. Storing the dehumidifier When not using the dehumidifier for long time periods - Press the drying inside button .
Troubleshooting (Before contact our customer service, review this list. It may save your time and expense. This list includes the most common occurrences that are not the result of defective workmanship or materials in this dehumidifier.) Issue Cause Solution Normal Operation When the unit is in dehumidifying mode it absorbs humid air from room and freezes it to reduce the humidity.
TECHNICAL DATA SDZ１-70p/p Model Color white Power supply 110~120V/60Hz Power input (w) 520 Rated current(A) 8 Specification Moisture Removal (80°F,RH 60%) Water tank capacity(Water full)(Liter) Refrigerant Features 7 R410A 42 Noise level (dbA) Type 70 Mechanical/Electronic Electronic Timer 24H Display LED water-full alarm YES cloth-dry function YES Continuous drianage function YES Frost prevention YES Net Weight (Kg) 19.5 Specification Body size(ＩＮ) 24.2 × 14.9 x 10.
Warranty TO OBTAIN WARRANTY SERVICE: Please contact us by email. Sales support: service@shinco.net WARRANTY PERIOD: Labor: 1 Year from the Date of Purchase. Parts: 1 Year from the Date of Purchase. SHINCO Electric Co., Ltd reserves rights to upgrade products without user notice.
