Warranty

Using Your Blender:

WARNING: Avoid contact with moving parts.

1. Place the Motor Base on a clean, flat surface.

2. Fill your Glass Jar with your favorite ingredients; do not fill past the Max line.

CAUTION: Add liquids first and do not overfill the product or operate it when

empty.

3. Insert the Glass Jar to the Motor Base turn until the slots are in place and

lock.

4. Add the lid with the Filler Cap in place.

Note: The Filler Cap allows you to add ingredients while blending.

5. Connect Plug to the nearest 120 V AC electrical outlet.

6. Pulse your beverage to the consistency and speed of your preference.

Note: Push the Hi/Low Button for Speeds 1-6, and leave the button out for

High Speeds 7-12

Attention: First use may cause a slight odor or small smoking upon heating,

it is normal. This is a result of the heating element chemical reaction. It quickly

goes away.

7. When you have finished blending, press the pulse/off button. Make sure the

blades have come to a complete stop before attempting to remove the jar

from the base. Turn the Jar counter clockwise to remove from the base.

8. Lift Jar from base remove the lid and serve.

Blending Tips:

 When blending thick mixtures such as smoothies, power drinks or

milkshakes; press the pulse button several times to begin the blending

process.

 Filler cap should only be removed to add ingredients. Do not remove the lid

while the blender is in use.

 Large foods should be chopped before placing into blender.

 While the appliance is OFF you can use a rubber spatula to scrape the sides

of the jar. Make sure you removed all utensils before continuing replace the

Lid and blend.

 The Lid cap holds up to 60ml of liquid and can be used to measure when

adding ingredients.

 Please do not use your blender to make Bread Crumbs, Grinding Coffee

Beans, and Chopping Nuts, Whipping Cream, Beating Egg whites, Mixing

Dough, Mashing Potatoes, Grinding Meats or Extracting Juice.

 When using the Pulse function use short bursts. Allow the blades to stop

completely between pulses. Do not Pulse for more than 2 minutes.

 It is recommended to begin blending at a low speed and gradually

increasing if necessary.

 If you will blend warm ingredients still steaming, remove the filler cap

covering the opening with a cloth to avoid splattering and blend only on the

lowest speed. This allows any steam to escape.

 Do not blend any of the following products in your blender: