| OPERATION & INSTALLATION UNPACKING YOUR ICE MAKER + Remove the exterior and interior packaging. Check if all the accessories, including the instruction manual, ice scoop, white water inlet pipe, 4 ways to 2 ways water quick connector and the water draining pipe, etc, are present. If any parts are missing, please contact our customer service. + Remove the tape for fixing the door and inner cabinet, ice soap, ete. Roughly clean the inner cabinet & ice scoop with a wet cloth.
| OPERATION & INSTALLATION To ensure proper ventilation for your ice maker, the front of the unit must be completely unobstructed {at least 20CM free space). Allow at least 50 mm clearance at the back, and 50 mm at the top and sides for proper air circulation. The installation should allow the ice maker to be pulled forward for servicing if necessary. ‘When installing the ice maker under a counter, follow the recommended spacing dimensions as shown above.
| OPERATION & INSTALLATION CLEANING YOUR ICE MAKER BEFORE USING FOR THE FIRST TIME Before using your ice maker, iris strongly recommended to clean it thoroughly. # Open the ice collecting door. ¢ Clean with diluted detergent, warm water and a soft cloth. * Repeatedly clean the water contacting inner parts, you can pull the Water drainpipe of the water tank indicating “IT” in above illustration to drain the cleaned water in the water tank.
| OPERATION & INSTALLATION * Connect the water hose to the water faucet of the water main supply system First, install the supplied water quick-connector to the water faucet by screw thread Second, remove the clipper from the water quick-connector, insert the other end of the water hose into this Buick-connector port completely, then install back the clipper, also this step is completed Note: The water faucet should be supplied by the customer himself.
| OPERATION & INSTALLATION * Arab ice making cycle is around 11-minutes. The ice making time will be changed according to the ambient temperature and the water temperature change. Especially the first ice making cycle, the ice making cycle will be longer because of the high-water temperature in the water tank, but the ice making cycle will not be longer than minute. Adjust the ice thickness. Press -" button on the control panel to adjust the ice thickness.
| OPERATION & INSTALLATION * Automatic self-cleaning program. The default cleaning Hume is 20 minutes. Start the self-cleaning program: After connecting all the water pipes, plug on the main power supply plug, then press “TIMER CLEAN" button on control panel for more than 5 seconds, to enter the self-cleaning program. The symbol @ rotate on the display screen, and the time counts down area displays 20M.
