SDS

IDH number: 701942 Product name: FAST CURE MIXER CUPS 1 OZ
Page 2 of 5
Ingestion:
DO NOT induce vomiting unless directed to do so by medical personnel. Keep
individual calm. If symptoms develop and persist, get medical attention.
5. FIRE FIGHTING MEASURES
Flash point:
> 93 °C (> 199.4 °F) Tagliabue closed cup
Autoignition temperature:
Not available
Flammable/Explosive limits - lower:
Not available
Flammable/Explosive limits - upper:
Not available
Extinguishing media:
Foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear self-contained breathing apparatus and full protective clothing, such as
turn-out gear.
Unusual fire or explosion hazards:
Closed containers may rupture (due to build up of pressure) when exposed to
extreme heat.
Hazardous combustion products:
Oxides of carbon. Irritating organic fragments.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Do not allow product to enter sewer or waterways.
Clean-up methods:
Remove all sources of ignition. Immediately contact emergency personnel.
Scrape up as much material as possible. Clean residue with soap and water.
Store in a partly filled, closed container until disposal.
7. HANDLING AND STORAGE
Handling:
Keep away from heat, spark and flame. Do not breathe
gas/fumes/vapor/spray. Keep container closed. Avoid contact with eyes, skin
and clothing. Wash thoroughly after handling.
Storage:
Keep in a cool, well ventilated area away from heat, sparks and open flame.
Keep container tightly closed until ready for use. Store in original container
until ready to use.
For information on product shelf life contact Henkel Customer Service at [phone].
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.
Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER
Epichlorohydrin-4,4'-isopropylidene diphenol resin None None None None
Aluminium hydroxide
10 mg/m3 TWA (as
Al) Total dust.
1 mg/m3 TWA
Respirable fraction.
15 mg/m3 TWA (as
Al) Total dust.
5 mg/m3 TWA (as
Al) Respirable
fraction.
None None
Titanium dioxide 10 mg/m3 TWA
15 mg/m3 TWA
Total dust.
None None
Engineering controls:
Provide adequate local exhaust ventilation to maintain worker exposure below
exposure limits.