SDS

IDH number: 1552177 Product name: LOCTITE® 3370™ POLYURETHANE ADHESIVE/SEALANT
Page 2 of 6
4. FIRST AID MEASURES
Inhalation:
Move to fresh air in case of accidental inhalation of vapours. If symptoms
develop and persist, get medical attention.
Skin contact:
Wash with soap and water. If symptoms develop and persist, get medical
attention.
Eye contact:
In case of contact with the eyes, rinse immediately with plenty of water for 15
minutes, and seek immediate medical attention.
Ingestion:
Do not induce vomiting. Consult a physician if necessary.
5. FIRE FIGHTING MEASURES
Flash point:
40 °C (104°F) ; Estimated
Autoignition temperature:
> 200 °C (> 392°F)
Flammable/Explosive limits - lower:
6 %
Flammable/Explosive limits - upper:
7 %
Extinguishing media:
Foam, dry chemical or carbon dioxide.
Special firefighting procedures:
Wear a self-contained breathing apparatus with a full face piece operated in
pressure-demand or other positive pressure mode.
Unusual fire or explosion hazards:
In case of fire toxic gases can be released.
Hazardous combustion products:
Oxides of carbon. Oxides of nitrogen. Irritating vapors.
6. ACCIDENTAL RELEASE MEASURES
Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected
personnel.
Environmental precautions:
Do not allow material to contaminate ground water system.
Clean-up methods:
Wipe up with adsorbent material (e.g. cloth, fleece). Scrape up spilled material
and place in a closed container for disposal.
7. HANDLING AND STORAGE
Handling:
When using, do not eat, drink or smoke. Keep away from heat, spark and
flame.
Storage:
Store away from ignition sources. Keep in a cool, well ventilated area. Keep
container closed.
For information on product shelf life contact Henkel Customer Service at [phone].
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure
controls and protective equipment for each task performed.