Instructions / Assembly

1.Cut 6” or desired width from left side

Install

2.Cut 6” or desired width from right side

Install

left wall panel

Match spacer back to lower panel and install panels using spacer back in middle vertical grout line

for uniform grout lines

HDS3660- 106K (O & B)

(Cut to size specification sheet)

PAGE 1
HDS3660- 106K (O & B) (Cut to size specification sheet) 1.Cut 6” or desired width from left side Install 2.Cut 6” or desired width from right side Install 3.
PAGE 2
4. Start with ½ diamond in Right back corner wall, (2) strips for both right and left walls. and run consecutively (4) strips for back 5a. Cut 42” or desired height from bottom of panel 5b. Install piece or inside knee wall 6a. Cut 6” or desired width from right side 6b. Cut panel at 30” Install both pieces seamed together or back wall upper section. (Use spacer bar between design strip and upper section if desired) 7.