Installation Guide

Determine the height of where you want to place the lower Soter-

raSlate Soap Dish from the oor. Once you have identied where

you want the lower dish, mark the bottom line with a pencil.

Clean area thoroughly with denatured alcohol where you will

place (2) 10" strips of velcro for 10” dish and (2) 6” strips for 6”

dish on the wall. Place the top of the triangle supports (included)

where the bottom of the soap dish will be placed.

Make sure the Velcro does not go above the support as this

would not allow the soap dish to press against the wall.

Remove the paper cover from the back of the Velcro and press

rmly to the wall.

Then place the supports on the top of the velcro strips on the

inside corner and outside edge of velcro. The supports must be

5 ½" from the corner of the shower on the 6" soap dish and 9 ½"

on the 10" soap dish.

Make sure the outside supports are 1/8" higher than the inside

supports so that the water drains off the center/back of the dish.

After applying all four soap dish supports, dry t soap dish to

make sure it is level and placed where desired.

How to Install a Soterra Soap Dish:

Lesson Continues on the Following Page

Extras—Installing A Soap Dish