Installation Guide
Bullnose Trim
Ogee Trim
How to Cut SoterraSlate Bullnose & Ogee Trim:
1
2
3
The SoterraSlate system offers two trims options, Bullnose (see
picture) and Ogee Trim (see picture). Handle the trim with care,
they are fragile.
Bullnose Trim is 1” thick x 1” tall x 18” long.
Ogee Trim is 2” thick x 1 1/4” tall x 18” long. The Ogee trim can
be installed in two different design options. The at edge can be
installed inward or outward, depending on which angle best ts
your wall design.
To identify the amount of trim you’ll need for your project, make
a drawing and measure the outside dimension. Account for the
outside miter corners by adding 2” per corner. Divide the total
amount of inches by 18, which will equate to the total number of
trims required to cover the perimeter of your shower.
The trims can be cut with a tile saw or a 7” circular hand saw in
combination with an angle square. Use a spring clamp to secure
the trim and square during your cutting process (see picture 2).
Determine where the trim will be placed around your shower
making sure the seams are where you want them. To
accomodate for mitered corners, make sure there is at least 2” to
3” to complete the miter.
Once you’ve nalized your trim placement, mark the trims in the
order they will be installed. Apply masking tape to the trim and
mark where the cuts or miters will be made.
Make sure you have maximized the trim to
minimize waste. The Shower Kit Conguration
comes with one extra trim for safe measure.
2
Lesson Continues on the Following Page
Trim Lessons—Cutting Trim
WWW.SOTERRADIY.COM 20