Installation Guide

Dry t the Design Strip prior to peeling the backing on the adhe-

sive and then align the bottom of the Design Strip to the spacer

bar or panel and roll on lightly. Once satised with position you

can use the roller to secure in place.

Be sure that all of the adhesive from panel below is removed

prior to installing the Design Strip. Once installed roll the Panels

and Design Strips together so that they are ush with each

other. Fill the joints with the coordinating color of the CEG Epoxy

Grout:

Golden Sand-Sealed & Enhanced=Earth #105

Multi Color-Sealed=Natural Gray #109/Enhanced= Earth #105

Verde River-Sealed=Natural Gray #109/Enhanced= #105

Peacock-Sealed & Enhanced=Earth #105

Rustic-Sealed & Enhanced=Earth #105

Follow the mixing directions of the selected Epoxy Grout and

apply the mixture into all grout lines using the oat (picture 6).

After all grout lines are full make sure to have a clean bucket of

water and reccomended sponge to remove the excess grout.

Repeat by cleaning sponge until you have a smooth surface

between all lines and the residue is removed from the Desig

Strip.

* It may be necessary to use denatured alcohol and a clean cloth

to remove any residue that may have run onto the lower section

panels. This should be done within 30 minutes of nishing grout

application.

How to Install SoterraSlate Design Strips (continued):

Design Strip Lessons—Installing Design Strips