Installation Guide

Each SoterraSlate Design Strips is 4" H x 18" L, and has a peel &

stick strip applied to the back for easy installation (see picture 1).

If desired, you can use template material that is supplied with the

SoterraSlate panels. Cut the cardboard to 4” x 18” strips or 4 1/4”

x 18” if you opt for a grout joint between the strips and panels

(see picture 2). Please note, you can use the Design Strip itself

as a template and a cardboard template is not necessary.

Make sure to rmly secure the strip when cutting (see picture 3).

Prior to cutting, make sure all strips are lined up according to a

pattern and diamonds are coordinating.If you run into an issue,

peel the piece off and replace it with the design that you need.

How to Cut SoterraSlate Design Strips:

Design Strip Lessons—Cutting Design Strips