Installation Guide

35½"
35½"
36"
36"
35½"
35½"
Example: Model 3060-76DS (see
Diagram 6-B) – the panel removed
illustrates the difference in one panel
not being square. Please note, use
the factory edge as the level line and
always cut where the panel aligns with
the base or upper trim. ting.
How to Template & Measure (continued):
4
Diagram 6-B
In Diagram 6-C, the upper panels are
similar to Diagram 6-A. If the inside
of (H) is higher than outside bottom
corner of (I) then your template should
reect this, never assume something is
square.
5
Diagram 6-C
H
F
J
I
G
K
Lesson Continues on the Following Page
Do-It-Yourself Setup—Templating & Measuring
WWW.SOTERRADIY.COM 8