Third Party Verification Claim

Page 97 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
67.7
If the ionizing can be energized with the fan not
functioning or with particle filters removed, the test
described in 67.2 – 67.6 is to be repeated with the
fan not operating or with particle filters removed
N/A
68
Dielectric Voltage-Withstand Test
P
68.1
As a routine production-line test, each appliance
shall be subjected to the application of a potential
at a frequency within the range of 40 –
70 hertz
P
Between the primary wiring, including connected
components, and accessible dead-metal parts that
are likely to become energized and
P
Between primary wiring and accessible low
voltage (42.4 volts peak or less) metal parts,
including terminals
P
68.2
Each power supply cord terminating in a swivel
assembly shall be subjected to a test potential
between
N/A
Line conductors and
N/A
Each line conductor and grounding conductor, if
provided
N/A
The 40 – 70 hertz test potential is to be 1,250 volts
maintained for 60 seconds or 1,500 volts
maintained for 1 second. The test is to be
conducted prior to assembly of the appliance
N/A
Exception: The end product manufacturer is not
required to conduct the test if
N/A
The power supply cord-swivel assembly
combination has been investigated with respect to
the requirements covering wiring harnesses and
N/A
The test is conducted as a routine production- line
test by the manufacturer of the power supply cord-
swivel assembly combination
N/A
68.3
The production-line test described in 68.1 shall be
in accordance with either condition A or B of
Table 68.1. The results are acceptable if there is
no dielectric breakdown
N/A
68.4
The appliance may be in a heated or unheated
condition for the test
N/A
68.5
The test described in 68.1 shall be conducted
when the appliance is complete (fully assembled).
It is not intended that the appliance be unwired,
modified, or disassembled for the test.
N/A
Exception No. 1: A part such as a snap cover or
friction fit knob that would interfere with conducting
the test is required to be in place.
N/A