Third Party Verification Claim

Page 96 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
66.4.1
A polymeric material employed in a Class
105 (A) insulation system in accordance with the
Exception to 28.4.3 is to be aged for the amount of
time corresponding to an aging temperature that
appears on the Class 105 (A) system response
shown in Figure 66.1. The motor insulation system
is to cool to room temperature and the applicable
dielectric voltage-withstand requirements specified
in Section 45 are to be applied between live parts
and noncurrent-carrying metal parts that are
isolated from each other by the material under
consideration
N/A
67
Ozone Test
N/A
67.1
Grooming appliances employing ionization circuitry
shall not produce a concentration of ozone
exceeding 0.05 parts per million by volume when
tested as described in 67.2 – 67.7
N/A
67.2
The test is to be conducted in a room having a
volume of 950 – 1100 cubic feet (26.9 – 31.1 m3)
with a minimum side dimension of 8 feet (2.4 m)
and a maximum height dimension of 10 feet (3.0
m) without openings. The test room walls and
ceiling are to be covered with a sheet of
polyethylene or aluminum. The floor is to be of a
nonporous material such as vinyl tile or aluminum
N/A
67.3
During the test, the test room is to be maintained
at a temperature of 25 2°C (77
4°F) and a relative humidity of 50 5 percent.
Prior to the start of this test, the ozone background
level is to be measured with the product off. The
background level shall be subtracted from the
maximum measurement during the test
N/A
67.4
The product is to be located in the center of the
test room floor for floor supported product and
about 30 – 36 inches (762 – 910 mm) above the
floor for table-mounted or hand-held product
N/A
67.5
The ozone monitor sampling tube is to be located
2 inches (50 mm) from the air outlet of the product
and is to point directly into the air stream
N/A
67.6
The product shall be operated at maximum ozone
output and the emission of ozone shall be
monitored for 7 hours to determine the
concentration
N/A
Note: For hairdryers, the maximum ozone output
condition is typically low heat and low speed
N/A
Exception: For attended grooming appliances,
such as hand-supported hair dryers, etc., the
appliance is to be operated in the same manner
and for the length of time specified as for the
temperature test described in Section 44
N/A