Third Party Verification Claim

Page 90 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
Exception: Physical properties of the component
are not required to be investigated if it is removed
during an abnormal operation test. During and
after the abnormal operation test, the Leakage
Current Test, Section 38, and the Dielectric
Voltage-Withstand Test, Section 45, are to be
conducted. Acceptable test results for the leakage
current and dielectric voltage- withstand tests are
specified in 38.1 and 45.3
N/A
62.2
The test procedure for determining whether a
component complies with the requirements
specified in 62.1 depends upon the material of
which it is composed, its size and shape, the mode
of application in the appliance, and similar criteria.
The test procedure includes visual inspection for
cracks, deformation, and similar deterioration after
accelerated aging and a comparison of hardness,
tensile strength, and elongation before and after
accelerated aging.
N/A
62.3
With respect to 62.1 and 62.2, a component of
rubber, neoprene, or thermoplastic material shall
be tested to compare its tensile strength and
elongation before and after artificial aging. The
results are acceptable if the properties are found
to be no less than the minimum values indicated in
Table 62.1 corresponding to the temperature of
the component during the temperature test
N/A
Exception No. 1: A part that is too small to be a
practical subject of the physical properties
measurements in Table 62.1 shall show no
cracking or significant deformation or change in
hardness after accelerated aging as determined by
visual inspection
N/A
62.4
As an alternative to the air oven aging specified in
Table 62.1, the acceptability of a liquid container,
seal, or diaphragm may be determined by means
of an aging test on the complete appliance under
service conditions
N/A
63
Label Adhesion Test
P
63.1
To determine if a pressure-sensitive label or a
label secured by cement or adhesive meets the
requirements for its intended use, representative
samples that have been subjected to the tests
specified in 63.2 – 63.7 shall meet all of the
following conditions
P
Each label shall demonstrate strong adhesion and
the edges shall not be curled
P
The label shall resist defacement or removal as
demonstrated by scraping across the test panel
with a flat metal blade 1/32 inch (0.8 mm) thick
held at a right angle to the test panel, and
P
The printing shall be legible and shall not be
defaced by rubbing with thumb or finger pressure
P