Third Party Verification Claim

Page 9 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
9.1.5
An appliance, or any item furnished with an
appliance, shall have no sharp edge, burr, point,
or spike inside or outside the appliance that results
in injury to persons during intended use and
maintenance
P
9.1.6
On an appliance adjustable for height, means shall
be provided for holding the upper parts securely in
position. Means shall also be provided to prevent
the upper part from descending rapidly if the
securing means loosens or fails to operate as
intended.
N/A
9.1.7
A hand-supported hair dryer shall have each air
intake opening provided with a screen or
equivalent means so that there are no openings
larger than 0.004 square inch (0.03 cm2)
N/A
9.2
Appliances with reservoirs
N/A
9.2.1
An appliance in which liquid reaches a
temperature greater than 46°C (114.8°F) shall
comply with the requirements specified in 9.2.2
– 9.2.4, 36.1 – 36.3, and 37.2
N/A
Exception No. 1: An electrode-type appliance is
not required to comply with these requirements.
For requirements for an electrode-type appliance,
see Sections 78 – 84
N/A
9.2.2
The construction of the appliance shall reduce the
risk of injury to persons under conditions of
intended use. Openings through which liquid can
be emitted shall not be provided unless such
openings are needed to perform an operating
function
N/A
9.2.3
An appliance with a vessel or container with a
capacity of more than 32 fluid ounces (946 mL)
shall be provided with a fully inserting or a lock- on
lid
N/A
9.2.4
If any part of an appliance requires assembly (for
example, engagement of a twist-lock part), then
improper assembly that results in a risk of injury to
persons shall be clearly visible to the user
N/A
9.3
Wax depilatory appliances
N/A
9.3.1
The maximum temperature of the wax, measured
as described in 44.2.1 – 44.2.3, shall not exceed
75°C (167°F)
N/A
9.3.2
The maximum temperature rise of surfaces that
may be contacted by the user shall be as specified
in Table 44.2
N/A
9.3.3
When there are multiple heat settings (for
example, a setting for maintaining molten wax at
the intended temperature for application to all of
the skin and a higher heat setting for quick melting
of solid wax), the appliance shall comply with all of
the following
N/A