Third Party Verification Claim
Page 66 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: 0769-81710286 E-mail: wangzhao@junantest.com Website: www.junantest.com
46.1.6
A steam-type curling iron or mist-type hair styler
having an integral liquid reservoir shall be
subjected to an overfill test consisting of pouring a
solution of hard water as described in
46.1.5 into the reservoir. The amount of solution
shall be 200 percent of the intended capacity of
the reservoir. During the test the appliance is to be
held in its fill position and the leakage current is to
be continuously monitored. There shall not be the
leakage current exceeding that specified in the
Leakage Current Test, Section 38. Immediately
following the test, the sample shall be subjected
to a 2,500-volt dielectric voltage- withstand test as
described in the Dielectric Voltage-Withstand Test,
Section 45. There shall not be dielectric
breakdown
N/A
46.1.7
In order to determine if a steam-type hair curler
having an integral liquid reservoir will need to have
the wording specified in 74.7(g)(16), the appliance
shall be subjected to a water droplet test
consisting of pouring a solution of hard water, as
described in 46.1.5, into the reservoir. The amount
of solution shall be the specified capacity of the
reservoir. During the test the appliance is to be
energized at rated wattage.
The appliance steam control system is to be
actuated continuously, commencing with the
appliance cold, and ending beyond the point when
the appliance becomes fully heated. If no water
droplets are emitted from the steam vents at any
time during the test, the appliance Important
Safety Instructions need not include the
information described in 74.7(g)(16)
N/A
46.2
Hair dryers – drape test
N/A
46.2.1
A bonnet-style hair dryer shall be operated without
the use of a dummy head until all temperatures
stabilize, and then draped with a double layer of
cheesecloth
N/A
46.2.2
A handheld hair dryer shall be placed on a flat,
horizontal softwood surface, operated until all
temperatures stabilize, and then draped with a
double layer of cheesecloth.
N/A
46.2.3
The cheesecloth shall be draped in a manner so
as to retard the air flow and cover the hottest area
of the hair dryer but not be deliberately
manipulated to cause an overly restrictive air flow
N/A
46.2.4
The hair dryer shall be operated for 8 hours or until
stabilized conditions are apparent, whichever is
longer. The cheesecloth shall not discolor, glow, or
flame as a result of this test
N/A
46.3
Hair dryer locked rotor test
N/A
46.3.1
The sample from the drape test shall be used for
this test
N/A