Third Party Verification Claim

Page 41 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
28.2.3
A motor control device not having a horsepower
rating equivalent to the motor it controls, shall be
capable of performing effectively when subjected
to an overload test as specified in the Motor
Control Overload Test, Section 56
N/A
28.3
Overload protection
N/A
28.3.1
Except as indicated in 28.3.8, the following
appliances in which a 1 hp or smaller motor is
used shall incorporate thermal or overload
protection that prevents the motor from attaining
excessivetemperatures under any operating
conditions
N/A
A remotely or automatically controlled appliance
and
N/A
A permanently connected, continuous-duty,
manually started appliance
N/A
An impedance-protected motor is not required to
have additional thermal or overload protection.
N/A
28.3.2
An appliance intended to be automatically or
remotely controlled, and employing a motor rated
at more than 1 hp, shall incorporate thermal or
overcurrent protection
N/A
28.3.3
Fuses shall not be used as motor-overload-
protective devices unless the motor is protected by
the largest size of fuse that can be inserted in the
fuseholder
N/A
28.3.4
Thermal protection devices integral with the motor
shall comply with one of the following:
N/A
The Standard for Overheating Protection for
Motors, UL 2111
N/A
The Standard for Thermally Protected Motors, UL
1004-3; or
N/A
The Standard for Automatic Electrical Controls for
Household and Similar Use, Part 1: General
Requirements, UL 60730-1; and the Standard for
Automatic Electrical Controls for Household and
Similar Use; Part 2 Particular Requirements for
Thermal Motor Protectors, UL 60730-2-2; in
conjunction with the Standard for Thermally
Protected Motors, UL 1004-3 (to evaluate the
motor-protector combination)
N/A
28.3.5
Impedance protection shall comply with the
Standard for Impedance Protected Motors, UL
1004-2
N/A
28.3.6
Electronic protection integral to the motor shall
comply with the Standard for Electronically
Protected Motors, UL 1004-7
N/A
28.3.7
Electronically protected motor circuits shall comply
with one of the following
N/A