Third Party Verification Claim

Page 31 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
23.1.6
A timer or time switch, incorporating electronic
timing circuits or switching circuits, with or without
separable contacts, shall comply with the
requirements for an operating control with Type 1
action for 6000 cycles of operation, or as a manual
control for 5000 cycles of operation, in accordance
with the following
N/A
The Standard for Automatic Electrical Controls for
Household and Similar Use; Part 1: General
Requirements, UL 60730-1; and the Standard for
Automatic Electrical Controls for Household and
Similar Use; Part 2: Particular Requirements for
Timers and Time Switches, UL 60730-2-7 or
N/A
The Standard for Solid-State Controls for
Appliances, UL 244A.
N/A
23.1.7
A manually operated, line-connected, single-pole
switch for appliance on-off operation shall not be
connected to the conductor of the power supply
cord or circuit intended to be grounded. Table
13.3 specifies the identification of
the power supply cord conductor intended to be
grounded.
N/A
23.1.8
A switch that is subjected to a temperature of more
than 65°C (149°F) shall be evaluated with respect
to the temperature limitations of the materials
used.
N/A
23.1.9
A switch shall be located or protected so that it will
not be subjected to mechanical damage during
use
N/A
23.1.10
A switch, as required in 23.1.1, shall have a plainly
marked off position. The use of a symbol alone,
such as the symbol
O, shall not be used to denote the off
position. The switch position marking need not be
an integral part of the switch itself.
N/A
Exception: An appliance that is provided with a
momentary contact on-off switch that automatically
returns to the off position when the actuator is
released is not required to have a marked off
position.
N/A
23.1.11
A hand-supported hair-drying appliance is not
intended to be immersible and shall not be so
marked
N/A