Third Party Verification Claim

Page 3 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
6
General
P
6.1
In the following text, a requirement that applies
only to a specific type or types of appliances, such
as a hand-supported hair dryer and a curling iron,
is so identified by specific reference in that
requirement to the type or types involved.
Absence of such specific reference or use of the
term appliance indicates that the requirement
applies to all appliances covered by this standard.
P
6.2
An appliance that is a combination of two or more
types (for example, an appliance having a hand-
supported part and a counter-supported part), or an
appliance that fits the definition of two or more
types (for example, an appliance that can be used
while supported by hand or while supported by a
counter top), is to be investigated in accordance
with the applicable requirements for the types of
appliances involved. If two requirements that
address the same condition differ, the appliance is
to be investigated to the more severe requirement
P
6.3
A heated air curling iron or brush, as defined in
5.25, shall comply with the requirements
applicable to hand-supported hair dryers and
curling irons
N/A
6.4
A container for liquid intended for use with the
appliance, and supplied as part of the appliance,
shall comply with applicable construction
requirements.
N/A
6.5
A curling iron that is likely to be laid on
combustible material shall be provided with a
stand made of material resistant to combustion
upon which it may be placed when not in use.
N/A
Exception: A stand need not be provided if the
temperature attained by the appliance is not
sufficiently high to cause the ignition of the
combustible material
N/A
6.6
A curling iron that attains a temperature higher than
100°C (212°F) when operated continuously shall be
provided with an integral stand. A stand provided for
other types of appliances may be a separate device
or integral with the appliance.
N/A
6.7
With respect to 6.6, an integral stand provided for a
curling iron shall be of such design or shape that
any surface of the curling iron exceeding 150°C
(302°F) will not contact the supporting surface
when the curling iron is supported in its intended
manner by the stand
N/A
6.8
A polymeric material used as an integral stand in
compliance with the requirements in 6.7 shall be
rated for the temperature it is subjected to during
use.
N/A
7
Hair Dryer Immersion Protection
N/A