Third Party Verification Claim

Page 19 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
With the plug aligned with the pins and the face of
the plug in a plane located perpendicular to the
end or ends of the farthest projecting current-
carrying pin, the probe illustrated in Figure 8.1
shall not touch any current-carrying pin while the
probe is inserted through any opening with the
appliance in any position
N/A
13.3.2.3
When the pins on the appliance are of American
National Standard configuration, the plug used in
13.3.2.2(b) shall consist of an appliance plug in
accordance with the Standard for Wiring Devices
– Dimensional Requirements, ANSI/NEMA WD6
N/A
13.3.2.4
When the pins on the appliance are not of an
American National Standard configuration, the
plug used in 13.3.2.2(b) shall be the plug supplied
with the appliance – 125 volts, 10 amperes, and
250 volts, 5 amperes
N/A
13.3.2.5
When an appliance uses three or more pin
terminals intended for use with a plug that covers
all the pins, the terminals shall be spaced so that
they will not accommodate a flatiron, appliance
plug, or cord connector.
These pins shall accommodate the plug required
for the particular application
N/A
13.3.2.6
A pin terminal shall be securely and rigidly
mounted and shall be prevented from shifting in
position by means other than friction between
surfaces
N/A
13.3.2.7
The requirement specified in 13.3.2.6 is intended
primarily to provide for the maintenance of
spacings as specified in 26.1.6, and to maintain
required spacings between pin terminals. Under
this requirement, consideration is also to be given
to the means for locking terminals in position to
maintain tightness
N/A
13.3.2.8
For a heating appliance, the dimensions of pins
and their center-to-center spacings (including the
corresponding spacings of the female contacts of
general use plugs that these arrangements of pins
will accommodate) shall be as indicated in Table
13.4
N/A
13.3.2.9
he material on which the pins are mounted, the
proximity of any vapor outlet to the terminals, and
the direction of the vapor spray shall be such that
water shall be prevented from accumulating at the
terminal
N/A
13.4
Strain relief
P
13.4.1
Strain relief shall be provided such that stress on a
flexible cord will not be transmitted to a terminal,
splice, or internal wiring in the appliance or in a
fitting (attachment plug, appliance plug, or similar
componen
P