Third Party Verification Claim

Page 18 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
13.3.1.15
Appliances provided with a detachable base or
stand subject to repeated connection and
disconnection during normal use shall not pose a
risk of electric shock, fire or injury when mated or
disconnected under any orientation or polarity
permitted by the construction. The mating
connector shall be held securely in place and shall
not be allowed to rotate. Compliance is determined
by the test of 65.6 and 65.7
N/A
13.3.1.16
Appliances provided with a detachable base or
stand intended to power a hand-supported
appliance which may be disconnected from power
during normal use shall not tip over when the
hand-supported portion of the appliance is
assembled as intended to the base. Compliance is
determined by the stability test of 65.8 and 65.9
N/A
13.3.1.17
Locking features provided in accordance with
(a) and (b) in the Exception to 13.3.1.2 shall be
formed and assembled to have the strength and
rigidity required to resist the abuses to which it is
able to be subjected. Compliance is determined by
the test of 65.10
N/A
13.3.1.18
Female contacts and live parts associated with
connectors for appliances intended to be
disconnected under load during normal use shall
not have exposed contacts or terminals accessible
to the probe in Figure 13.3.
N/A
Exception: Exposed contacts or terminals are
acceptable if located in a secondary circuit and all
of the following conditions are met
N/A
The maximum output voltage (Vmax) does not
exceed 42.4 volts peak (30 Vrms).
N/A
The output current does not exceed 8 amperes
under any connection of loading including and up
to short circuit for ac or dc voltages up to 42.2 V
peak (30 Vrms)
N/A
13.3.1.19
A cord reel shall comply with special use cord
reel requirements of the Standard for Cord Reels,
UL 355. For products provided with cord tag, the
cord tag shall not retract into cord reel
N/A
13.3.2
Pin terminals
N/A
13.3.2.1
When an appliance is provided with pin terminals,
the construction of the appliance shall be such that
no live part will be exposed to unintentional
contact both during and after the placement of the
plug on the pins in the intended manner
N/A
13.3.2.2
When an appliance is provided with pin terminals,
a pin guard is required, such that
N/A
A straight edge placed in any position, including
across and in contact with edges of the plug
opening without the plug in place, cannot be made
to contact any current-carrying pin
N/A