Third Party Verification Claim

Page 105 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: 0769-81710286 E-mail: wangzhao@junantest.com Website: www.junantest.com
72.5.3
The reverse side of the warning tag or the marking
on the wall unit or on the hand unit shall provide
the pictorial warning illustrated in Figure 72.2, or
the equivalent. The illustration shall consist of a
black outline on a contrasting color background,
with the slash mark in red. The height of the
illustration shall be no less than 1 inch (25.4 mm)
and the width shall be no less than 2 inches (50.8
mm). The headings DO NOT REMOVE THIS
TAG! And WARN CHILDREN OF THE
RISK OF DEATH BY ELECTRIC
SHOCK! Shall be in black letters no less than
3/16 inch (4.8 mm) in height. All lettering shall be
in block letters
N/A
72.5.4
The warning tag shall be permanently affixed to
the cord of the hand unit, no more than 6 inches
(152.4 mm) from the wall unit and shall be made
of substantial material (cardboard, cloth, plastic, or
the equivalent) to provide mechanical strength and
to prevent easy removal. All exposed surfaces
shall have a clear plastic overlay, or the
equivalent, to protect the markings. The tag shall
comply with the requirements specified in the Test
for Permanence of Cord Tag for Hand-Supported
Hair-Drying Appliances, Section 58. The tag shall
be either of the following forms
N/A
A flag-type tag having a hole to permit securement
to the cord of the hand unit by a plastic strap or
equivalent means. The strap shall not be
removable without cutting
N/A
A flag-type tag with an adhesive back. The tag is
to be wrapped tightly once around and is to
adhere to the cord of the hand unit. The ends of
the tag are to adhere to each other and to project
as a flag. The required markings are to be
positioned on the projecting flag portion of the tag
N/A
72.5.5
A permanently installed wall-mounted hair dryer
shall be marked on the wall unit or on the wall
bracket where readily visible during installation
with the word DANGER and the
following or the equivalent: To reduce the risk of
death by electric shock, install only where hand
unit cannot reach tub, sink, or shower . The height
of the letters in the word DANGER shall be no less
than 1/8 inch (3.2 mm) and the height of the
remaining letters shall be no less than 1/16 inch
(1.6 mm). The letters shall be in a color which
contrasts with the background.
Block lettering shall be used for all words
N/A
Exception: The marking need not be in contrasting
colors if the letters are embossed or indented to a
depth of not less than 0.020 inch (0.5 mm)
N/A
72.6
Curling irons
N/A