Third Party Verification Claim

Page 102 of 129 Report No.: JAT2209271146SR-1
UL 859
Clause
Requirement + Test
Result - Remark
Verdict
Room 303, Building 1, No.316, Renzhou Road, Shatian Town, Dongguan City, Guangdong Province, China.
Tel: [phone] E-mail: [e-mail] Website: www.junantest.com
72.1.9
Cleaning of the appliance or similar servicing by
the user involves the exposure of any normally
enclosed or protected live part to unintentional
contact, the appliance shall be plainly marked to
indicate that all such servicing is to be done with
the appliance disconnected from the supply
circuit.
P
72.1.10
An appliance having field-wiring terminals rated for
supply connection using aluminum wire shall be
marked with the following or the equivalent, as
appropriate for the terminals. This marking shall be
independent of all other markings on terminal
connectors and shall be visible during and after
installation
N/A
Use Aluminum Conductors Only or Use Aluminum
or Copper-Clad Aluminum Conductors Only if the
terminal is intended for connection to aluminum
wire only
N/A
Use Copper or Aluminum Conductors or Use
Copper, Copper-Clad Aluminum, or Aluminum
Conductors if the terminal is intended for
connection to either copper or aluminum wire
N/A
72.2
Body- or table-supported hood- or bonnet-type hair
dryers
N/A
72.2.1
A hand-, shoulder-, or table-supported hair dryer
provided with a rigid hood or bonnet intended to
be placed over or directly on the head while in use
shall be marked in letters no less than 7/64 inch
(2.8 mm) high with the word WARNING
and the following or the equivalent: To
reduce the risk of possible electric shock do not
use while bathing . The marking shall be
located adjacent to the controls or in a location
that is readily visible during positioning of the hood
or bonnet. The marking may be located inside the
hood or bonnet on the headband.
Equivalent information shall be included in the
instructions packed with the unit
N/A
Exception: The marking is not required on an
appliance that has been investigated and
determined to be immersible. An appliance that
complies with the requirements in the Hair Dryer
Immersion Protection, Section 7, is not deemed to
be immersible.
N/A
72.3
Dual-voltage appliances
N/A
72.3.1
An input voltage selector shall be marked to
indicate each individual voltage position
N/A
72.4
Hand-supported hair-drying appliances
N/A