Installation Guide

Tulip Royal Bench
Assembly Instructions
*WARNING* Heavy! Handle with care! Keep children away from assembly area!
Tools Required: Adjustable wrench
Parts List:
Side Frame 2 Screws 4
Seat 1 Flat Washers 8
Back Rest 1 Lock Washers 8
Hex Head Bolt 4 Nuts 4
Assembly:
We suggest you assemble the unit on a soft surface to avoid damage to the finish.
Step 1 – Attach the seat section to both side frames. First (2) hex head bolts thru the hole in the
first side frame piece. Then align the hex head bolts with the holes in the Seat and slip
them thru. To secure the Seat to the first Side Frame piece use a Flat Washer, a Lock
Washer and a Nut, in this order. HAND TIGHTEN ONLY AT THIS POINT. Follow
the same procedure for the second Side Frame piece.
Step 2 – Attach the back section to the Side Frame Pieces. On both of the Side Frame Pieces there
will be 2 Back Rest mounting Tabs. First place a Lock Washer and a Flat Washer onto a
Hex Head Bolt in that order. Align the Threaded holes in the Back Rest with the thru
holes in the Back Rest mounting tabs of the Side Frames and secure using the Hex Bolt,
Lock Washer and Flat Washer assembly. HAND TIGHTEN ONLY AT THIS POINT.
Follow this procedure for the remaining three Back Rest Mounting tabs.
Step 3 – Stand the unit upright on a flat surface and align the sides with seat and back so the unit is
level and the legs are parallel.
Step 4 – Now tighten the bolts to lock the unit in its permanent configuration. *Caution: Unit is
constructed of cast metal and is brittle. Do not force any part of the assembly and do not
over-tighten the fasteners as damage my occur.
After assembly is completed and before first use verify the chair sits level and is stable.
** Maintenance Recommendation:
1) Oxidation of cast iron: The cast iron component of the product is finished with a powder coating process
that protects the iron from rusting. However, due to the nature of the iron, rusting is inevitable. It is
recommended that the consumer touch up any surface that is scratched or damaged due to wear and tear.
Applying an epoxy clear coating is recommended once a year.
2) Aluminum: The products with aluminum components please be reminded that aluminum is soft metal it is
therefore necessary to exercise caution when tightening nuts/bolts/screws on aluminum parts to prevent
damaging the treads on the metal.
3) Solid Brass Fasteners: The fasteners provided are made with solid brass. This item will tarnish after
weathering. A brass polish can be use to keep the screws shiny or you can leave it untouched to give it a
patina/antique look.
Please do not return product to place of purchase – for customer service issues please
call 1-248-652-1404 to speak with customer service between the hours of 9am and 5pm
Eastern Standard Time. You may also fax or E-Mail any questions or comments to
1-248-652-1105 / [e-mail].
1010-20040909