Installation Guide

ManualsBrandsUnbranded ManualsCurtain Rod BracketsDouble Rod Converter Bracket in Silver (2-Pack)

Double Rod Converter Bracket Installation Instructions

Step 1: Determine rod height

• Place a curtain panel onto a rod section.

• Lift rod and curtain to desired height above the

window.

• Mark rod height on the wall in pencil.

Step 2: Mark bracket locations

• Determine bracket positions on either side of the

window.

• Up to 48” use two brackets.

• 48” to 96” use three brackets.

• 96” to 144” use four brackets.

• The top of the bracket should align with rod height

determined in Step 1. If using third or fourth bracket,

space them evenly between outer brackets.

• Mark screw locations with pencil.

Step 3: Drill holes and secure brackets

• For wood mounting, drill 1/8” (3 mm) holes and

secure brackets using 2 screws per bracket. Do not

use wall anchors.

• For hollow walls, drill 3/16” (4.7 mm) holes. Gently

tap wall anchors into holes then secure brackets

using 2 screws per bracket.

Step 5: Install front curtains

• Repeat Step 4 for front curtain panels and front rod.

Step 6: Hand-tighten thumb screw

• Adjust rod to desired position in bracket then hand-

tighten the thumb screw to secure rod in position.

• Center rod to nest into front indentation for a tight fit.

wood wall hollow wall

Includes You will need:

4x Screws 4x Plastic

Screw

Anchors

Pencil Phillips head

Screwdriver

Drill with bits

1/8” & 3/16”

Care Instructions: Wipe clean with a damp cloth. Do not use abrasives or detergents as they may damage the finish.

DCB_171121S

Step 4: Install back curtains

• Slide back curtain panels onto back rod, with panels

divided evenly across the window.

• Screw finials onto the ends.

• Set rod into brackets.

2x Mounting Brackets

with Thumb Screws

Summary of content (2 pages)

PAGE 1
Double Rod Converter Bracket Installation Instructions Includes 2x Mounting Brackets with Thumb Screws 4x Screws You will need: 4x Plastic Screw Anchors Pencil Step 1: Determine rod height • Place a curtain panel onto a rod section. • Lift rod and curtain to desired height above the window. • Mark rod height on the wall in pencil. For wood mounting, drill 1/8” (3 mm) holes and secure brackets using 2 screws per bracket. Do not use wall anchors. • For hollow walls, drill 3/16” (4.7 mm) holes.
PAGE 2
Instrucciones para la instalación de soportes de convertidores de doble barra Incluye 2x soportes de montura con tornillos de palomilla 4x tornillos Necesitará: 4x tarugos de plástico Lápiz Paso 1: Determine la altura de la barra • Coloque un paño de la cortina en una sección de la barra. • Levante la barra y cortina a la altura deseada por sobre la ventana. • Marque la altura de la barra en la pared con un lápiz. Paso 3: Perfore los agujeros y asegure los soportes.