Use and Care Manual

ENGLISH

HOW TO OPERATE

Before rst use, carefully unpack your MILK FROTHER, remove all packaging materials, and

then follow the cleaning instructions under the CLEANING & MAINTENANCE section.

WARM AND THICK FOAM

1. Place the milk frother upright on a dry, sturdy and heat-

resistant surface near an electrical outlet.

2. Take the lid o and insert the frothing paddle onto the shaft on the bottom of the frother.

3. Fill the jar with the desired amount of milk and put the lid on.

NOTE: Minimum milk capacity for WARM & THICK FOAM is 3 oz. Max capacity is 5 oz.

Refer to chart to decide how much milk to put in - type of milk used may vary.

4. Connect the plug into an electrical outlet and place frother onto base.

5. Press the FUNCTION button once and the WARM &

THICK FOAM indicator light will illuminate.

6. Press the ON/OFF button to begin frothing process.

NOTE: This setting will take approximately 50 to 90 seconds. The frother

will turn o automatically when cycle is nished. If you want to stop the

frothing process at any moment, press ON/OFF button once.

7. Take frother o base, remove lid and pour out warm froth and enjoy.

CAUTION: Minimum 3 minutes rest time must be maintained between cycles

otherwise frother will stop and will ash, indicating that it needs to cool down.

WARM AND THIN FOAM