SDS

Section 5 – Accidental Release Measures
Action: Restrict persons not wearing protective equipment from areas of spills or leaks
until cleanup is complete. Remove ignition sources and ventilate area.
Large Spill: Contain spill. Prevent runoff from entering drains, sewers or streams.
Dispose in accordance with all applicable federal, state and local health and
environmental regulations.
Small Spill: Contain spill. Follow same procedure as above for large spill.
Section 6 – Hazards Identification & First Aid Measures
HMIS HAZARD RATINGS
Health – 2
Fire – 0
Reactivity – 0
Personal Protection–See Section 8
Routes of Entry: Product may enter the body via eye contact, skin contact and ingestion.
Potential Health Effects: N/A
Eye: Eye contact with product may cause irritation. Avoid eye contact with product.
VisionBay, LLC represents that this product qualifies for exemption from registration
under the Federal Insecticide, Fungicide and Rodenticide Act.
The information contained herein is based on data considered accurate. However, no
warranty is expressed or implied regarding the accuracy of this data or the results to be
obtained from the use thereof. VisionBay, LLC assumes no responsibility for personal
injury or property damage to the Vendee, Users or Third Parties caused by the material.
Such Vendees or Users assume all risks associated with the use of this material.
FIRST AID MEASURES
Eye Contact: Immediately flush eyes with a directed stream of water for at least 15
minutes while forcibly holding eyelids apart to ensure complete irrigation of all eye and
lid. Seek Medical Attention if Irritation Persists.
Skin Contact: Flush skin with water and wash with soap and water. If clothing is
penetrated, immediately remove clothing and flush skin with water. Wash clothes before
reuse. Get Prompt Medical Attention If Irritation Occurs.
Ingestion: Give 2 glasses of water. Do not induce vomiting. If spontaneous vomiting
is inevitable, Prevent Aspiration by keeping victim’s head below the knees. Get
Immediate Medical Attention.
Inhalation: Remove to fresh air. If breathing is difficult, have trained person
administer oxygen. If respiration stops, have trained person administer mouth-to-mouth
resuscitation. Get Medical Attention Immediately.
Section 7 – Stability and Reactivity
Hazardous Polymerization: Hazardous polymerization will not occur.
Materials to Avoid: Avoid contact with strong oxidizing and reducing agents.
Conditions to Avoid: See Section 9.
Hazardous Decomposition Products: Not Known. See Section 6.