Instructions / Assembly

7
GRIDSCAPE FIXED PANEL
INSTALLATION INSTRUCTIONS – FULL DIVIDED-LIGHT
STEP 7. SECURE PANEL FROM INTERIOR
STEP 8. SEAL UNIT EXTERIOR
➢ To complete the installation, run a bead of clear (or matching color)
mildew resistant caulking around the outside perimeter of the shower at
the Sill CST 998 and the Wall Jamb CST 956.
➢ For a unit installed without screwing the Sill down to the curb, run a
bead of silicone caulk on both the outside and inside of the Sill.
➢ IMPORTANT: Do not block the weep holes when caulking to the inside.
➢ Follow the caulking manufacturer’s instructions before using the shower.
➢ Secure the Panel from the interior of the enclosure using Panel
Adjustment Screws 834QO (#8 x 3/4” Pan Head Combo Drive
(Black Head)). Drill 9/64” pilot holes 3/4” deep at each Screw location.
➢ Secure the Panel to the Wall Jamb CST 956 with (3) Screws at top,
middle and bottom. Locate Screws at 1/4” from the edge of the
Panel. Place Screws at 5” from the top and bottom of the Panel.
➢ Secure the Panel to the Sill CST 998 with (3) Screws at left, right,
and center. Locate Screws at 1/4” from the edge of the Sill. Place
Screws into the Panel outside vertical stiles at 1/2” from the left and
right Panel edges.
Outside Shower
Enclosure
5”
5”
1/4”
CST 956
PANEL
CST 998
CST 998
PANEL
1/4”
PANEL
CST 956
834QO (3x)
834QO (3x)
CST 998
CST 956
CAULKING
CENTER
Inside Shower Enclosure
9/64” PILOT HOLES
834QO (3x)
834QO (3x)
IMPT: DO NOT BLOCK
WEEP HOLES TO INSIDE
CST 998
CAULKING