Instructions / Assembly

GRIDSCAPE FIXED PANEL

INSTALLATION INSTRUCTIONS – FULL DIVIDED-LIGHT

➢ Place the Sill CST 998 on the curb centerline with weep holes to the inside of

the enclosure. Push the Sill against the wall under the Wall Jamb CST 956.

➢ OPTIONAL: Secure Sill to curb with Screws.

➢ Drill 3/16” holes through the Sill at (3) pre-drilled 3/8” holes in the Sill.

➢ Drill 3/16” holes 1-1/2” deep into the curb at the (3) pre-drilled holes in the Sill.

➢ Insert Plastic Screw Anchors 1329 into the holes.

➢ Secure the Sill using (3) Installation Screws 6-8114PHP (#8 x 1-1/14”).

STEP 6. SET PANEL AND INSTALL COVER AND SILL CAP

➢ Set the Panel into the Sill CST 998 and push it onto the

Wall Jamb CST 956. The metal grid is to the outside.

➢ Attach the Panel Snap Cover CST 952 to the exposed

vertical edge of the Panel using a rubber mallet.

➢ Adjust the Panel onto / off the Jamb until the Snap Cover

is flush with the end of the Sill.

➢ Insert the Sill End Cap CP967B into the end of the Sill.

CST 952

CP967B

CST 998

PANEL

CST 952

CST 998

CP967B

STEP 5. SET SILL AND * SECURE TO CURB (*OPTIONAL)

CST 998

6-8114PHP (3x)

CST 998

1329 (3x)

Outside Shower

Enclosure

WEEP HOLES

TO INSIDE

PANEL

FLUSH

CST 952

CST 956

3/8” HOLE (3x)

3/16” DRILL BIT

*OPTIONAL