Instructions / Assembly

ManualsBrandsUnbranded ManualsPlayground Sets & EquipmentGriffin Outdoor Music Playset Accessory

GRIFFIN

Producing rich, full tones, this aluminum resonated metallophone

has anodized aluminum chimes. Patterned after the

Swirl

the warm tones linger for three to five seconds,

making it similar to finger painting with sound.

C MAJOR PENTATONIC

PROPRIETARY AND CONFIDENTIAL

THE INFORMATION CONTAINED IN THIS

DRAWING IS THE SOLE PROPERTY OF

FREENOTES HARMONY PARK. ANY

REPRODUCTION IN PART OR AS A WHOLE

WITHOUT THE WRITTEN PERMISSION OF

FREENOTES HARMONY PARK IS

PROHIBITED.

FREENOTES HARMONY PARK

194 BODO DRIVE, UNIT F

DURANGO CO 81303

TEL: (970) 375-7825

FAX: (970) 247-0856

EMAIL: INFO@FREENOTESHARMONYPARK.COM

WWW.FREENOTESHARMONYPARK.COM

SHEET 1 OF 6

SCALE: 1:16

PRODUCT SHEET / INSTALLATION GUIDE

GRIFFIN 2016

Summary of content (6 pages)

PAGE 1
GRIFFIN Producing rich, full tones, this aluminum resonated metallophone has anodized aluminum chimes. Patterned after the Swirl, the warm tones linger for three to five seconds, making it similar to finger painting with sound. C MAJOR PENTATONIC 1 26 4 " 1 47 4 " 1 48" FREENOTES HARMONY PARK 194 BODO DRIVE, UNIT F DURANGO CO 81303 TEL: (970) 375-7825 FAX: (970) 247-0856 EMAIL: INFO@FREENOTESHARMONYPARK.COM WWW.FREENOTESHARMONYPARK.
PAGE 2
MOUNTING OPTION IDENTIFICATION: This instrument is offered with various mounting options. Identify your option below and follow installation instructions on the following sheets.
PAGE 3
RECYCLED AND STEEL POST IN-GROUND INSTALLATION PROCEDURES Step 1: Excavate two 10" diameter hole, 36" deep, and 18 5/8" on center at the installation location. Contractor can modify post to desired height. Post Length = Frost Depth (36" Recommended) + Finished Height (Refer to Height Guideline) Step 2: Lower the posts into the excavated holes. Step 3: Refer to sheet 6 for installation of instrument to posts.
PAGE 4
RECYCLED AND STEEL POST SURFACE MOUNT INSTALLATION PROCEDURES Step 1: Determine installation location. Verify concrete footing is a minimum of 6" thick. If the concrete pad is at an angle, steel washers are required to act as shims. (Shims not provided) Step 2: Stand the surface mount post upright onto the concrete pad with a 18 5/8" offset on center. Mark the center of the holes on the surface mount plates. After you have made your marks, set aside the posts in order to drill for anchor holes.
PAGE 5
WALL MOUNT INSTALLATION PROCEDURES Step 1: Mount the Wall Mount Posts to playing surface at the desired Finished Height, (Refer to Finished Height Guideline) and at 18 5/8" on center. If mounting to Concrete use the provided Anchor Bolts. Anchor holes should be drilled to a depth of 3" with a 3/8" Masonry Bit. The same steps 2 and 3 on Sheet 4 can be used for Anchor Bolt installation.
PAGE 6
INSTRUMENT TO POST INSTALLATION PROCEDURES Step 1: (Recycled Post Only) With two people, situate the instrument onto the posts. Predrill 1/8" pilot holes into the posts through the existing holes on the instrument holster. Fasten the instrument to the posts with the provided 1 1/4" tamper-resistant screws and security driver. (Steel Post Only) With two people, situate the instrument onto the posts. Predrill 11/64" pilot holes into the posts through the existing holes on the instrument holster.