User Manual

8
(1)、GH3-3D塑胶三轴无刷云台只需连接3S锂电便可独立工作，内置BEC模块，可给接收机供电。
Gimbal RC connection has BEC output, by which the receiver can be individually powered.
七、云台测试 Gimbal Test
1、云台水平稳固安装到飞行器上，相机安装在云台上，使相机镜头的朝向与机头朝向一致。
2、正确连接遥控线，若需要连接图传，把图传模块连接相机和云台，再把图传连接线连接图传。
3、打开遥控器，给云台上电，等待云台自检。初始化完成，云台相机与机头保持一致，横滚轴和俯仰轴保持水平。
拨动遥控器上用于控制云台PITCH轴的开关，观察云台PITCH轴的转向是否与您设置的一致，如果不一致，请检
查连接线和遥控设置。
4、测试完毕，断开云台电源。
1. Install gimbal on aircraft horizontally, and mount camera on gimbal. Please make sure the orientations
of camera and aircraft are the same.
2. Connect the RC wires correctly. If need a FPV, please connect the FPV module to camera and gimbal,
and then connect the FPV wire to FPV.
3. Turn on radio, power gimbal and wait for self-checking of gimbal. After initialization is completed, make
sure the orientations of camera and aircraft are the same and pitch and toll axes are horizontal. Slide the
switch to control pitch axis on radio. Check if the rotation direction is the same as your setting. If not,
please check the connections and radio settings.
4.Test finished, switch off the power.
当接收机有除了云台以外的其他电源供电时，必须挑出RC连接的红色线，否则会烧坏接收机。
When the aircraft shares a receiver with the gimbal (individual UBEC, or ESC with UBEN supplying
power to the receiver), in order to avoid burning out the receiver, you must cut the red 5V wire
(where the Gimbal supplies power to the receiver). But if the receiver has no power supply from the
ESC or UBEC, do not cut the red 5V wire.
注意 caution：
(1)请先安装相机到云台上，再通电。
(2)上电时YAW轴必须和机头方向一致，上电时的YAW轴方向就是上电后正常工作的方向。
(3)上电时必须保持静止，等待初始化完成后，云台正常工作。
(4)上电后正常工作时出现ROLL轴和PITCH轴偏离水平位置、YAW轴出现偏转等情况时，云台断电，连接GUI重
新校准陀螺仪
(1)
(2) Adjust the gimbal YAW axis and plane YAW axis to the same angle. The direction of YAW when
powering is the direction of normal working after powering.
(3) Do not move the Gimbal while Gimbal is powering on (or resetting).
(4) If pitch axis and roll axis are not horizontal or Yaw axis drifts obviously, please power off the gimbal, and
connect GUI to calibrate gyro again.
Please install Gopro camera with Gimbal before powering the Gimbal.
注意 caution：