User Manual

7
注意 caution：
使用遥控控制时不能选择估算
Estimate: It is good to improve the stability when pitch axis is in big angle by estimating angle.
Suggest using this mode when the angle of inclination of aircraft is too big.
按照下面顺序进行固件升级，否则导致固件升级失败和云台工作异常
3.1 计算机连接互联网
3.2 三轴云台与电脑通过micro USB线连接，升级完成前不要断开micro USB连接线
3.3 打开云台调参软件并且选择正确的com端口
3.4 点击“固件更新”，在弹出新窗口后点击“获取版本”获取最新的固件版本，点击“更新固件”等待
固件更新完成提示
Please follow this sequence to update firmware, or it may cause failure or abnormal.
3.1 Computer connected to the Internet
3.2 Gimbal connected to computer by micro USB. Do not switch off micro USB before update finishes.
3.3 Open Configuration software and then select the right com port.
3.4 Click ‘firmware update’; get the latest update version by click ‘get version’ after seeing the new
window. Click ‘firmware update’ and wait for the tip to tell update finishes.
普通：
电脑串口选择、连接、断开、校正、读取和写入；固件版本号和当前温度。
General: serial port on computer selection, connect, disconnect, calibrate, read and write;
version and current temperature
GUI版本号 GUI Version No.
5
状态显示Status display
6
3、固件升级 Firmware update
注意 caution：
(1)Do not switch off micro USB before update finishes.
(2)If there is abnormal in this process, please repeat steps above and update again.
(1) 更新过程请勿插拔micro USB连接线
(2) 在更新过程中出现异常，重复以上步骤，重新更新固件
六、云台供电系统 Gimbal Power Supply System