User Manual

八、云台校准 Gimbal Calibration
1、点击端口选择的下拉列表框，选择正确的电脑串口。
2、点击“连接”。
3、先把云台放置在水平位置（横滚和俯仰），点击“校正”，等待“校正成功”
点击“写入”，在这过程一定保持静止。等待“写入成功”
4、点击“断开”校准完成。
5、断开USB线，云台航向轴处于正前方，给云台上电，观察各轴是否处于水平位置，否则就重新校准。
1. Click port to select the right port of computer.
2. Click‘connect’.
3. Keep the gimbal horizontal (pitch and roll), and click ‘calibrate’ and wait ‘calibration successfully’.
Click ‘write’ and please keep gimbal static during this period. Wait ‘write successfully’.
4. Click ‘disconnect’. Calibration finished.
5. Disconnect USB. YAW axis is at right ahead. Power gimbal. Check if all axes are at horizontal position. Or
recalibrate.
9