Installation Guide

RECOMMENDED TOOLS
- 2 -
PARTS LIST
1
5 6 7 8 9
2 3 4
Rubber Mallet
Utility Knife
Flathead Screwdriver
Locking Pliers
Circular Saw
Construction
Grade Adhesive
Hole Saw
Silicone
Measuring Tape
When used in conjunction with a shower base that
has a nailing flange, the Jetcoat® Shower Wall System
is designed to be installed as shown in the drawing.
The nailing flange of the base should be attached
directly to the bare studs with backer board attached
to the studs above the nailing flange. The Jetcoat®
walls are installed on the backer board extending
down in front of the nailing flange and resting on the
base. Failure to install your base in this configuration
may cause problems installing the Jetcoat® walls.
STUD
BACKER
BOARD
SHOWER
WALL
SHOWER BASE
NAILING
FLANGE
NOTE:
SHOWER BASE INSTALLATION
OPTIONAL
Internal Corner Trim
Double-Sided
Construction Tape
OPTIONAL
Edge Trim
Beveled Edge Panel
LEFT
1
2
3
Beveled Edge Panel
RIGHT