Installation Guide

TIME AND CHIME SETTING:
CONGRATULATIONS -
You have purchased a quality clock
which plays the Westminster chime melody on the hour, tolls the hour and
has an automatic shut-off (clock does not chime between 10:00 p.m. and
6:00 a.m.). To ensure your clock functions correctly, please follow the
time and chime setting instructions precisely. The clock will chime during the day
and will automatically turn off at night.
1. Pull upwards the back panel of the top unit .
2. BEFORE inserting batteries set the clock at 6:05 AM with knob A.
3. Insert 1xAA alkaline battery into the clock battery chamber, according to
the positive (+) and negative (-) symbols.
4. Insert 2xAA alkaline batteries into the chime battery chamber, according to the
positive (+) and negative (-) symbols. Make sure batteries are secure in the
holder. The clock will chime automatically and toll 6 times.
5. Now turn hands(Using
knob A) slowly to the present hour (in a clockwise
direction).Remember that the clock started at 6:05 in the moming. if setting
at night,lets say, to 9:20 PM, then hands will be turned thus -- 7,8,9,10,11,
12,1,2,3,4,5,6,7,8,9, then 9:20.
N.B.: When moving hands to the present time, the clock will begin
chiming. Do not be concerned about this. the last strike you hear
after setting the clock at appointed time will be the correct one.
6. When replacing batteries, remember that all the above must be repeated
from point No 1 above. The clock must be started again at 6:05 a.m.
7. To eliminate chimes, remove the two batteries from the Chime
Battery Chamber.
8. Never tum clock hands counter clockwise as it will interrupt the chime
sequence and damage the clock.
N.B.: WHEN BATTERIES ARE LOW, CHIMES WILL NOT REMAIN
CO-ORDINATED WITH THE TIME ON THE CLOCK. WHEN
THIS HAPPENS, REPLACE WITH NEW ALKALINE BATTERIES
AND RESET CLOCK AS ABOVE.
PENDULUM SETTING:
1. Insert 2xC Alkaline batteries into the pendulum battery chamber according
to the positive (+) and negative (-) symbols.
2. For transport security, the small black plastic pendulum (B) may be attached
to the case (C) to prevent it from swinging.
3. At (D) use thumb pressure to gently push towards the right to loosen
the pendulum and allow it to swing freely.
10
12888
1. 5V
+-
+
+
-
-
(A)
CL OCK BATTERY CH A MBER
CH IME BATTERY CHA M BER
P EN DU L U M BATT ERY
CH A MBER
Battery-operated. Requires batteries. Do not mix old and new batteries.
Do not mix alkaline, standard batteries (carbon-zinc) or rechargeable
(nickel-cadmium) batteries.