Instructions / Assembly

Here are the simplified step-by-step instructions: after applying the OSB to your deck and
your coatings of the membrane and fitment of the drip edge. Refer below. (Roof top
decks)
1. Position Your Posts: Place your posts where they belong. Identify the corner posts
with holes on both sides. Make sure each post aligns with a truss
2. Prepare Support Blocks: Take the provided 2 x 6 wood piece and cut it into at least
8-inch lengths. Insert these pieces snugly inside the truss channels. Once your
support posts are in place, Mark the hole positions of the post (base plate holes)
and drill a hole from the top, all they way through the support block, Clap may be
required to hold the block in its position
3. Secure Your First Post: Apply sealant under the post you're securing. Use the
provided nut and bolt to attach the post
4. Repeat for Other Posts: Secure all the posts using the same method
5. Finish Up: Once all posts are securely in place, you can proceed with the rest of
your finishes
This method allows for a secure connection of the posts to the roof trusses, providing
stability and structural integrity to your construction.
2. Apply OSB and Seal: Please Note On the roof top deck models use the provided
Membrane coating for the roof also before applying the shingles
● Apply OSB to the roof top deck and seal it properly
3. Apply Membrane Coating:
● Apply a membrane coating to the OSB