Instructions / Assembly

pieces that help adjust the height and levelness of the track, ensuring it is installed evenly
on the foundation. As steel stud frames are true and accurate and if the foundation is not
level it will show up, caulk or a sealant will also assist in providing a good seal between the
concrete slab and the frame kit.
Other tips with the frame kit:
Sill Seal or Gasket: A sill seal, also known as a sill gasket or sill plate foam, is a compressible
foam or rubber material placed between the bottom track of the CFS (Cold-Formed
Steel/steel stud framing) frame and the concrete slab. It acts as a barrier to prevent
moisture infiltration and helps reduce the transfer of heat and cold. Sill seals also provide a
cushioning effect, allowing some flexibility in case of minor shifts in the foundation.
Moisture Barrier: A moisture barrier, often made of plastic or specialized waterproofing
membrane, is placed over the concrete slab before installing the sill seal and the bottom
track. This barrier prevents moisture from the concrete slab from seeping into the bottom
track,
Considerations for Hot and Snow Locations:
Using a house wrap inside Cold-Formed Steel (CFS) framing before installing insulation can
be beneficial in cold snow locations as well as hot locations, especially for managing
moisture and reducing condensation. House wraps typically function as vapor barriers,
preventing moisture from entering the wall assembly while allowing trapped moisture to
escape. Whether it is a wood structure or steel stud structure, this is recommended.
Faced Insulation Considerations
1. Vapor Barrier: Faced insulation typically has a paper or foil facing on one side. This
facing acts as a vapor barrier, reducing the transfer of moisture between the interior and
exterior of the building. In hot, humid climates, it prevents warm, moist air from entering
the wall cavity, reducing the risk of condensation inside the walls. Similarly, in snowy areas,
it prevents moisture from infiltrating the walls from the outside.
2. Installation Considerations: Proper installation is crucial. The facing should be installed
on the warm side of the wall. In cold climates, this is usually the interior side, while in hot
climates, it might be the exterior side. If installed incorrectly, faced insulation can trap
moisture inside the walls, leading to Mold and decay.