Installation Guide

 Floor primer
 Tools: Digital ohm meter, wire stripper, knife
Installation of One Dream Heat
Electrical Instruction
Thermostat Location
A thermostat must be used on all installations and must contain a ground
fault circuit interrupter (UL Listed, Class A type).
The thermostat should be installed about 1.5m (4.92’) above the wall on an inside wall,
making sure that it is easily accessible and reachable. Install the thermostat as
instructed in the installation instruction provided with the purchased thermostat.
Bottom Plate
Note that there are two holes on the bottom plate. One hole is for routing wires from
Dream Heat and other is for the thermostat sensor. These holes should be directly
below the electrical box(es).