Instructions / Assembly

30
TOP
COVER
3
4 - Align the holes on the side of the bottom wrap
with the holes on the top ofthe vertical.
If the holes are not there or the
cover does not reach
the holes simply drill a
new set of holes into
the vertical.
Secure the cover using
the #12 x 1/2” screws
provided.
#12X1/2” SCREW
1 ON EACH SIDE
IMPORTANT:
Make sure that the inside edge of
the top cover is securely positioned
over the edge of the ledges
4
3 - Insert the front of the top cover into the hole
in the front of the outside cover.
Pull the back of the
top cover down until
it securely fits under the
inside lip of the ledge.
Make sure the bottom
lip on the back
of the top
cover goes
over the back
edge of the ledge
(Fig. 4).
WRAP AROUND BOTTOM COVER
1 - Insert the logo into the bottom cover.
2 - Place the bottom cover onto the bottom of the vertical
and align the holes on the side of the wrap with
the holes on the bottom of the vertical.
3 - Secure the bottom cover using the #12 x 1/2” screws provided.
#12X1/2”
SCREW
1 ON EACH
SIDE
1
2
3